Bauplan in Originalgröße/Bohrungen

  • Hallo Raspy Freunde,
    Ich habe im Netz schon Baupläne für Cases gesehen aber nie vom Pi selbst. Ich möchte ganz gerne wissen wo die Bohrungen sich befinden um das in einem Bastelladen mal an Materalien anhalten zu können.

    Wenn es sowas nicht gibt könnte jemand freundlicherweise die Stellen der Bohrungen Ausmessen??? :)

  • Das Board selbst hat 85.60mm x 53.98mm (http://www.raspberrypi.org/phpBB3/viewtopic.php?f=2&t=1441)
    Die Position der Bohnungen findest Du hier: http://www.raspberrypi.org/archives/1929

    Zitat

    Mounting Holes!
    Two 2.5mm (drilled 2.9mm for M2.5 screw) non plated mounting holes have been provided to assist with ATE test mounting. Positions of these holes relative to the bottom left of the PCB (Power Input Corner) are:

    • Corner: 0.0mm,0.0mm
    • First Mount: 25.5mm,18.0mm
    • Second Mount: 80.1mm, 43.6mm

    Warning: If used to permanently mount the PCB – do not over tighten screws or drill out to fit larger screws, as this will lead to damage to the PCB.

Jetzt mitmachen!

Du hast noch kein Benutzerkonto auf unserer Seite? Registriere dich kostenlos und nimm an unserer Community teil!