Moin,
ich versuche gerade, an meinem B+ die Videoausgabe (Composite) zu drehen. Warum? Weil ich Torfkopp den Monitor instinktiv falsch herum ins Spielfeld eingebaut habe:Pffflipper. Und nein, ich kann den leider nicht einfach umdrehen, dat passt nicht
Drauf läuft Rasbian, die Config.txt im /boot sieht aus wie unten gezeigt. Leider hat der Parameter display_rotate keinerlei Einfluss, die Ausgabe wird nicht gedreht (nirgendwohin) . HDMI ist unbelegt. Kann mir einer von euch vielleicht sagen, was ich hier falsch mache?
Ciao,
Finger
Code
# uncomment if you get no picture on HDMI for a default "safe" mode
#hdmi_safe=1
# uncomment this if your display has a black border of unused pixels visible
# and your display can output without overscan
#disable_overscan=1
# uncomment the following to adjust overscan. Use positive numbers if console
# goes off screen, and negative if there is too much border
#overscan_left=16
#overscan_right=16
#overscan_top=16
#overscan_bottom=16
# uncomment to force a console size. By default it will be display's size minus
# overscan.
#framebuffer_width=1280
#framebuffer_height=720
# uncomment if hdmi display is not detected and composite is being output
#hdmi_force_hotplug=1
# uncomment to force a specific HDMI mode (this will force VGA)
#hdmi_group=1
#hdmi_mode=1
# uncomment to force a HDMI mode rather than DVI. This can make audio work in
# DMT (computer monitor) modes
#hdmi_drive=2
# uncomment to increase signal to HDMI, if you have interference, blanking, or
# no display
#config_hdmi_boost=4
# uncomment for composite PAL
sdtv_mode=2
sdtv_aspect = 1
display_rotate = 1
#uncomment to overclock the arm. 700 MHz is the default.
#arm_freq=800
# for more options see http://elinux.org/RPi_config.txt
# NOOBS Auto-generated Settings:
hdmi_force_hotplug=0
config_hdmi_boost=4
overscan_left=24
overscan_right=24
overscan_top=16
overscan_bottom=16
disable_overscan=0
Alles anzeigen