Hi Leute,
ich hab da so meine Probleme mit nem ESP8277-07.
Wie es im Topic steht kann ich ihn "mittlerweile" problemlos flashen.
Anschlussbelegung hierbei:
GND <-> GND
GPIO15 <-> 10k <-> GND
GPIO0 <-> 10k <-> GND
GPIO2 <-> 10k <-> V+
RST <-> 10k <-> V+
EN <-> 10k <-> V+
VCC <-> V+
Läuft einwandfrei. Danach bekomme ich im Seriellen Monitor aber nur das ausgegeben:
Nach nem Reset kommt immer nur Kauderwelsch, das lässt sich hier gar nicht posten.
Ich habe über einen FTDI mit nem CP2102 als auch über nen Arduino Nano geflascht.
Geflasht hab ich auch mal das billigste Blinkprogramm mit nem Serial output.
void setup() {
pinMode(LED_BUILTIN, OUTPUT); // Initialize the LED_BUILTIN pin as an output
Serial.begin(115200);
}
// the loop function runs over and over again forever
void loop() {
digitalWrite(LED_BUILTIN, LOW); // Turn the LED on (Note that LOW is the voltage level
// but actually the LED is on; this is because
// it is acive low on the ESP-01)
Serial.println ( "off" );
delay(1000); // Wait for a second
digitalWrite(LED_BUILTIN, HIGH); // Turn the LED off by making the voltage HIGH
Serial.println ( "off" );
delay(2000); // Wait for two seconds (to demonstrate the active low LED)
}
Alles anzeigen
Spannungsversorgung ist entweder ein gekaufter Regler oder ein LM1117 wo eingangs- und ausgangsseitig ein 100uF Elko angelötet ist.
Dazu ist auf der Flashingplatine noch ein 100nF zwichen GND und V+ gelötet. Befeuert von nem 750mA 5V oder einem 2,1A 5V Handyladegerät.
Gemessene Spannung am ESP sind 3,25V.
Weiss nicht, was jetzt noch an Infos fehlt. Fragt einfach, wenn ihr noch mehr Infos braucht.
Noch eine kleine Frage zum Schluss: Was muss im normalen Betrieb mindestens angeklemmt sein, damit der 07er stabil läuft? War das nur GND und V+ oder noch V+ auf EN o.Ä.?
Danke fürs Lesen und Helfen!