RasPi Camera + Motion

  • Hallo liebe Community,

    zur Zeit nutze ich Motion mit Bewegungserkennung auf meinem RaspberryPi und lasse mir das Video zuschicken, sobald die Aufnahme gemacht ist.

    Meine Frage ist nun, ob es einen Weg gibt Bilder zu machen, wenn motion gestoppt ist.
    Versuche ich dies über raspistill kommt immer folgende Fehlermeldung:

    Code
    mmal: mmal_vc_component_create: failed to create component 'vc.ril.camera' (1:ENOMEM)
    mmal: mmal_component_create_core: could not create component 'vc.ril.camera' (1)
    mmal: Failed to create camera component
    mmal: main: Failed to create camera component
    mmal: Camera is not detected. Please check carefully the camera module is installed correctly

    Ich hoffe ihr könnt mir helfen, denn meine Webbuche hat leider nichts ergeben!
    LG Jonesinho

    • Offizieller Beitrag

    Dei Picamera funktioniert mit motion aber einzeln nicht?

    Zitat von http://elinux.org/Rpi_Camera_Module


    Camera not working at all
    Example error message: "mmal: mmal_vc_component_create: failed to create component 'vc.ril.camera' (1:ENOMEM)"

    Make sure the flex cable is inserted the correct way on both ends, and each connector has the locking tab engaged. The RPi + camera draws about 260 mA more current when recording video, than without the camera. The Model B is about 550 mA by itself, so camera use pushes it over 800 mA. Some power supplies, cables, and polyfuses may not maintain 5V onboard at this current load well enough for reliable operation. You can check this with a voltmeter across TP1 and TP2.[15][16]

    • Offizieller Beitrag

    Also doch keine RaspiCam sondern eine stinknormale Usb WebCam?. Raspistill ist nicht, ohne grosse Umbaumaßnahmen in der Lage mit Standard USB Geräten zu reden, es wurde für die PiCamewra gebaut.

    Zitat

    Is it possible to have the camera board AND an USB camera connected at the same time?
    It seems that Motion MMAL internally tries to link vc.ril.camera to /dev/video0

    So, it a USB camera gets the device video0, we have a problem.

    I'm also using a logitech camera, and works great with standard version of motion.
    I can also get the camera board to play nicely with MMAL version of motion. But can't use both at the same time.

  • Hi,
    ich "kämpfe" auch immer noch damit!
    Recherchiert nach & gefunden habe ich:

    Das Problem besteht eigentlich aus zwei "Sachen"
    - der V4L / Video4Linux Treiber
    - und Motion Modul mit seinem Treiber / Device "Platzhalter" dev/videoX

    FAZIT:
    Motion benötigt also einen Gerät (mit dem es reden kann) unter motion/dev/video0 [1...]

    WARUM? immer wieder dass dev/video0?
    Weil es in der etc/motion/motion.conf so (default) implementiert wurde.

    Leider habe ich es noch nicht rausgefunden ..... wie, was, wo .... (momentan keine Zeit).

    LG
    Georg

    Sollte ich "Müll- reden" :blush: - bitte mich (?) "auf die Nuss" hauen. :huh:

Jetzt mitmachen!

Du hast noch kein Benutzerkonto auf unserer Seite? Registriere dich kostenlos und nimm an unserer Community teil!