Hallo,
ich bin im Urlaub und habe nur den Pi zur Hand.
Wenn ich den Pi mit dem Röhrenfernseher über den gelben Videoausgang verbinde, bekomme ich nur ein schwarz weiß Bild.
Ich habe gelesen, dass man irgendwas in der config.txt - Datei ändern muss.
Wie kann ich die Datei am Pi öffnen und bearbeiten?
Was muss ich dort dann eintragen damit ich Farbe sehe?
Auf meinem Handy habe ich die Mirco Sim Karte geöffnet und folgendes steht in der Config.txt Datei:
# uncomment if you get no picture on HDMI for a default "safe" mode
#hdmi_safe=1
# uncomment this if your display has a black border of unused pixels visible
# and your display can output without overscan
#disable_overscan=1
# uncomment the following to adjust overscan. Use positive numbers if console
# goes off screen, and negative if there is too much border
#overscan_left=16
#overscan_right=16
#overscan_top=16
#overscan_bottom=16
# uncomment to force a console size. By default it will be display's size minus
# overscan.
#framebuffer_width=1280
#framebuffer_height=720
# uncomment if hdmi display is not detected and composite is being output
#hdmi_force_hotplug=1
# uncomment to force a specific HDMI mode (this will force VGA)
#hdmi_group=1
#hdmi_mode=1
# uncomment to force a HDMI mode rather than DVI. This can make audio work in
# DMT (computer monitor) modes
#hdmi_drive=2
# uncomment to increase signal to HDMI, if you have interference, blanking, or
# no display
#config_hdmi_boost=4
# uncomment for composite PAL
#sdtv_mode=2
#uncomment to overclock the arm. 700 MHz is the default.
#arm_freq=800
# for more options see http://elinux.org/RPi_config.txt